#Traktor audio 6 case drivers
#Traktor audio 6 case driver

I don’t know if it’s necessary to do a reboot afterwards. It’s probably a good idea to do this in the ‘startup’ tab since this changes the device’s configuration to behave like this automatically every time you connect it to your computer. The solution is simple: Just open up the Audio 6 Control Panel and deactivate the checkbox for ‘direct thru’-mode. Go ahead - hook up your turntables and your CD decks. I had to deactivate this every time I used it. Traktor Audio 6 interface gives you all of the audio I/O you need. Looking at it from a little distance it’s something I could have known before because every time I had Traktor Scratch running and attached the Audio 6 to my computer I was presented with a ‘direct thru’-configuration for both decks. The device itself is not able to send audio data to these outputs in this case. Meaning: Everything that is connected to the inputs is directly routed to the outputs. The problem behind all this is that the Audio device’s input settings for both channels 3/4 and 5/6 was set to ‘direct thru’. Whatever I tried it only sent out real music (into my mixing desk) when I selected channel ‘1/2’ for Master out. I had a simple clip running on a track and changed the Master Out settings a few times. The screenshot only shows the output config but the input settings were accordingly. Recently in the middle of my mixes my songs will all of a sudden sound like they are being played through a completely blown speaker. I have 2 CDJ 900s and a DJM 800 Mixer and an Audio 6 sound card. Of course the settings in Ableton all were correct. I have been having an issue with my CDJs working with my sound card. Same problem on the inputs: I have two turntables attached to the Audio 6 and wanted to use their inputs within a vst-plugin (MsPinky, as you may have guessed) but I just wasn’t able to get any signals coming into Ableton.

#Traktor audio 6 case driver

Traktor Kontrol X1: This installs the driver for the TRAKTOR KONTROL X1 controller. If you do not in-tend to use any of these audio interfaces, you can deactivate the checkboxes.

#Traktor audio 6 case drivers

Everything else could be selected but just didn’t take effect (Ableton wasn’t even showing any kind of levels). Traktor Audio 2/6/10 Drivers: This installs the drivers for the TRAKTOR AUDIO 2, TRAKTOR AUDIO 6 and TRAKTOR AUDIO 10 audio interfaces by Native Instruments. Basically I couldn’t route Ableton’s output to anything different then ‘Output 1&2’ which is the main output at the Audio 6’s front side. I don’t know why I have never encountered this problem before but recently I tried to use my Traktor Audio 6 together with Ableton and had a fair share of problems.